Management Commands
615
ProSafe Managed Switch
no username snmpv3 authentication
Use this command to set the authentication protocol to be used for the specified user to
none. The <username> is the user name for which the specified authentication protocol is
used.
Format no username snmpv3 authentication <username>
Mode
username snmpv3 encryption
Use this command to specify the encryption protocol used for the specified user. The valid
encryption protocols are des or none.
If you select des, you can specify the required key on the command line. The encryption key
must be 8 to 64 characters long. If you select the des protocol but do not provide a key, the
user is prompted for the key. When you use the des protocol, the login password is also used
as the snmpv3 encryption password, so it must be a minimum of eight characters. If you
select none, you do not need to provide a key.
The <username> value is the login user name associated with the specified encryption. You
must enter the <username> in the same case you used when you added the user. To see
the case of the <username>, enter the show users command.
Default
Format username snmpv3 encryption <username> {none | des[key]}
Mode
no username snmpv3 encryption
Use this command to set the encryption protocol to none. The <username> is the login user
name for which the specified encryption protocol will be used.
Format no username snmpv3 encryption <username>
Mode
show users
Use this command to display the configured user names and their settings. This command is
only available for users with Read/Write privileges. The SNMPv3 fields will only be displayed
if SNMP is available on the system.
Format show users
Mode
Global Config
no encryption
Global Config
Global Config
Privileged EXEC
To Next Page
Loading...
