NETGEAR ProSafe GSM7224P - Chapter 7 IPv6 Commands

353
7
7. IPv6 Commands
This chapter describes the IPv6 commands available in the managed switch CLI.
Note: Commands described in this chapter that require a license are:
Tunnel Interface Commands
IPv6 Routing Commands
OSPFv3 Commands
OSPFv3 Graceful Restart Commands
DHCPv6 Commands
This chapter contains the following sections:
• Tunnel Interface Commands
• IPv6 Routing Commands
• OSPFv3 Commands
• OSPFv3 Graceful Restart Commands
• DHCPv6 Commands
The commands in this chapter are in three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
• Clear commands clear some or all of the settings to factory defaults.
Note: For information on IPv6 management commands, see IPv6
Management Commands on page 659.