NETGEAR ProSafe GSM7224P - Set Gmrp Interfacemode; Show Gmrp Configuration

Switching Commands
90
ProSafe Managed Switch
no set gmrp adminmode
This command disables GARP Multicast Registration Protocol (GMRP) on the system.
Format no set gmrp adminmode
Mode
set gmrp interfacemode
This command enables GARP Multicast Registration Protocol on a single interface (Interface
Config mode) or all interfaces (Global Config mode). If an interface which has GARP enabled
is enabled for routing or is enlisted as a member of a port-channel (LAG), GARP functionality
is disabled on that interface. GARP functionality is subsequently re-enabled if routing is
disabled and port-channel (LAG) membership is removed from an interface that has GARP
enabled.
Default
Format set gmrp interfacemode
Mode
• Interface Config
• Global Config
no set gmrp interfacemode
This command disables GARP Multicast Registration Protocol on a single interface or all
interfaces. If an interface which has GARP enabled is enabled for routing or is enlisted as a
member of a port-channel (LAG), GARP functionality is disabled. GARP functionality is
subsequently re-enabled if routing is disabled and port-channel (LAG) membership is
removed from an interface that has GARP enabled.
Format no set gmrp interfacemode
Mode
• Interface Config
• Global Config
show gmrp configuration
This command displays Generic Attributes Registration Protocol (GARP) information for one
or all interfaces.
Format show gmrp configuration {<unit/slot/port> | all}
Mode
• Privileged EXEC
• User EXEC
Privileged EXEC
disabled