NETGEAR ProSafe GSM7224P - GVRP Commands; Show Garp

Switching Commands
87
ProSafe Managed Switch
range from 200 to 6000 (centiseconds). The value 1000 centiseconds is 10 seconds. You can
use this command on all ports (Global Config mode) or a single port (Interface Config mode),
and it only has an effect only when GVRP is enabled.
Default
Format set garp timer leaveall <200-6000>
Mode
• Interface Config
• Global Config
no set garp timer leaveall
This command sets how frequently Leave All PDUs are generated the default and only has
an effect when GVRP is enabled.
Format no set garp timer leaveall
Mode
• Interface Config
• Global Config
show garp
This command displays GARP information.
Format show garp
Mode
• Privileged EXEC
• User EXEC
GMRP Admin Mode
GVRP Admin Mode
GVRP Commands
This section describes the commands you use to configure and view GARP VLAN
Registration Protocol (GVRP) information. GVRP-enabled switches exchange VLAN
configuration information, which allows GVRP to provide dynamic VLAN creation on trunk
ports and automatic VLAN pruning.
Note: If GVRP is disabled, the system does not forward GVRP messages.
1000
Term Definition
The administrative mode of GARP Multicast Registration Protocol (GMRP) for the
system.
The administrative mode of GARP VLAN Registration Protocol (GVRP) for the
system.