EasyManua.ls Logo

NETGEAR ProSafe GSM7224P - Internet Group Message Protocol (IGMP) Commands

NETGEAR ProSafe GSM7224P
740 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IP Multicast Commands
340
ProSafe Managed Switch
RP Address 192.168.20.1
Group Address 229.2.0.0
Group Mask 255.255.0.0
Origin Static
Expiry Time (hh:mm:ss) NA
Internet Group Message Protocol (IGMP) Commands
This section describes the commands you use to view and configure IGMP settings.
ip igmp
This command sets the administrative mode of IGMP in the system to active.
Default
Format ip igmp
Modes
• Global Config
• Interface Config
no ip igmp
This command sets the administrative mode of IGMP in the system to inactive.
Format no ip igmp
Modes
• Global Config
• Interface Config
ip igmp version
This command configures the version of IGMP for an interface. The value for <version> is
either 1, 2 or 3.
Default
Format ip igmp version <version>
Modes
no ip igmp version
This command resets the version of IGMP to the default value
.
Format no ip igmp version
Modes
disabled
3
Interface Config
Interface Config

Table of Contents

Related product manuals