Switching Commands
155
ProSafe Managed Switch
ip arp inspection validate
Use this command to enable additional validation checks like source-mac validation,
destination-mac validation, and ip address validation on the received ARP packets. Each
command overrides the configuration of the previous command. For example, if a command
enables src-mac and dst-mac validations, and a second command enables IP validation only,
the src-mac and dst-mac validations are disabled as a result of the second command.
Default disabled
Format ip arp inspection validate {[src-mac] [dst-mac] [ip]}
Mode
no ip arp inspection validate
Use this command to disable the additional validation checks on the received ARP packets.
Format no ip arp inspection validate {[src-mac] [dst-mac] [ip]}
Mode
ip arp inspection vlan logging
Use this command to enable logging of invalid ARP packets on a list of comma-separated
VLAN ranges.
Default enabled
Format ip arp inspection vlan vlan-list logging
Mode
no ip arp inspection vlan logging
Use this command to disable logging of invalid ARP packets on a list of comma-separated
VLAN ranges.
Format no ip arp inspection vlan vlan-list logging
Mode
ip arp inspection trust
Use this command to configure an interface as trusted for Dynamic ARP Inspection.
Default enabled
Format ip arp inspection trust
Mode
Global Config
Global Config
Global Config
Global Config
Interface Config
To Next Page
Loading...
