NETGEAR ProSafe GSM7224P - Vlan Pvid; Vlan Tagging

Switching Commands
72
ProSafe Managed Switch
no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is identified
by this <groupid>.
Format no protocol vlan group all <groupid>
Mode
vlan pvid
This command changes the VLAN ID per interface.
Default
Format vlan pvid <1-4093>
Mode
no vlan pvid
This command sets the VLAN ID per interface to 1.
Format no vlan pvid
Mode
vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to enabled.
If tagging is enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is
transmitted as untagged frames. The vlan-list contains VlanId's in range <1-4093>. Separate
non-consecutive IDs with ',' and no spaces and no zeros in between the range; Use '-' for
range.
Format vlan tagging <vlan-list>
Mode
no vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to disabled.
If tagging is disabled, traffic is transmitted as untagged frames. The vlan-list contains VlanId's
in range <1-4093>. Separate non-consecutive IDs with ',' and no spaces and no zeros in
between the range; Use '-' for range.
Format no vlan tagging <vlan-list>
Mode
Global Config
1
Interface Config
Interface Config
Interface Config
Interface Config