Management Commands
614
ProSafe Managed Switch
username <username> unlock
Use this command to unlock a user’s account. Only a user with read/write access can
re-activate a locked user account.
Format username <username> unlock
Mode
username snmpv3 accessmode
Use this command to specify the snmpv3 access privileges for the specified login user. The
valid accessmode values are readonly or readwrite. The <username> is the login user
name for which the specified access mode applies. The default is readwrite for the “admin”
user and readonly for all other users. You must enter the <username> in the same case
you used when you added the user. To see the case of the <username>, enter the show
users command.
Defaults
• admin - readwrite
• other - readonly
Format username snmpv3 accessmode <username> {readonly | readwrite}
Mode
no username snmpv3 accessmode
Use this command to set the snmpv3 access privileges for the specified user as readwrite
for the “admin” user and readonly for all other users. The <username> value is the user
name for which the specified access mode will apply.
Format no username snmpv3 accessmode <username>
Mode
username snmpv3 authentication
Use this command to specify the authentication protocol to be used for the specified user.
The valid authentication protocols are none, md5 or sha. If you specify md5 or sha, the login
password is also used as the snmpv3 authentication password and therefore must be at least
eight characters in length. The <username> is the user name associated with the
authentication protocol. You must enter the <username> in the same case you used when
you added the user. To see the case of the <username>, enter the show users command.
Default
Format username snmpv3 authentication <username> {none | md5 | sha}
Mode
Global Config
Global Config
Global Config
no authentication
Global Config
To Next Page
Loading...
Need help?
General