Stacking Commands
33
ProSafe Managed Switch
show checkpoint statistics
Use this command to display general information about the checkpoint service operation.
Format show checkpoint statistics
Mode
Messages
Checkpointed
Bytes
Checkpointed
Time Since
Counters Cleared
Checkpoint
Message Rate
Average
Last 10-second
Message Rate
Average
Highest
10-second
Message Rate
Example:
(Switch)#show checkpoint statistics
Messages Checkpointed.....................6708
Bytes Checkpointed........................894305
Time Since Counters Cleared...............3d 01:05:09
Checkpoint Message Rate...................0.025 msg/sec
Last 10-second Message Rate...............0 msg/sec
Highest 10-second Message Rate............8 msg/sec
clear checkpoint statistics
This command clears the statistics for the checkpointing process.
Format clear checkpoint statistics
Mode
Format initiate failover
Mode
Stack Global Config Mode
Privileged EXEC
Term Description
Number of checkpoint messages transmitted to the backup unit. Range: Integer. Def
ault:0
Number of bytes transmitted to the backup unit. Range: Integer. Default:0
Number of days, hours, minutes and seconds since the counters were reset to zero.
The counters are cleared when a unit becomes manager and with a support command.
Range: Time Stamp. Default: 0d00:00:00
Number of checkpoint messages per second. The average is computed over the time
period since the counters were cleared. Range: Integer. Default:0
Number of checkpoint messages per second in the last 10-second interval. This
average is updated once every 10 seconds. Range: Integer. Default:0
The highest rate recorded over a 10-second interval since the counters were cleared.
Range: Integer. Default:0
Privileged EXEC
To Next Page
Loading...
