NETGEAR ProSafe GSM7224P - Ip Vrrp Track Interface; Ip Vrrp Track Ip Route

Routing Commands
258
ProSafe Managed Switch
no ip vrrp timers advertise
This command sets the default virtual router advertisement value for an interface.
Format no ip vrrp <vrid> timers advertise
Mode
ip vrrp track interface
Use this command to alter the priority of the VRRP router based on the availability of its
interfaces. This command is useful for tracking interfaces that are not configured for VRRP.
Only IP interfaces are tracked. A tracked interface is up if the IP on that interface is up.
Otherwise, the tracked interface is down.
When the tracked interface is down or the interface has been removed from the router, the
priority of the VRRP router will be decremented by the value specified in the <priority>
argument. When the interface is up for IP protocol, the priority will be incremented by the
<priority> value.
A VRRP configured interface can track more than one interface. When a tracked interface
goes down, then the priority of the router will be decreased by 10 (the default priority
decrement) for each downed interface. The default priority decrement is changed using the
<priority> argument. The default priority of the virtual router is 100, and the default
decrement priority is 10. By default, no interfaces are tracked. If you specify just the interface
to be tracked, without giving the optional priority, then the default priority will be set. The
default priority decrement is 10.
Default
Format ip vrrp <vrid> track interface <unit/slot/port> [decrement
<priority>]
Mode
no ip vrrp track interface
Use this command to remove the interface from the tracked list or to restore the priority
decrement to its default.
Format no ip vrrp <vrid> track interface <unit/slot/port> [decrement]
Mode
ip vrrp track ip route
Use this command to track the route reachability. When the tracked route is deleted, the
priority of the VRRP router will be decremented by the value specified in the <priority>
argument. When the tracked route is added, the priority will be incremented by the same.
A VRRP configured interface can track more than one route. When a tracked route goes
down, then the priority of the router will be decreased by 10 (the default priority decrement)
Interface Config
priority: 10
Interface Config
Interface Config