Routing Commands
242
ProSafe Managed Switch
they were assigned the original default distance. The new default distance will only be
applied to static routes created after invoking the ip route distance command.
Default
Format ip route distance <1-255>
Mode
no ip route distance
This command sets the default static route preference value in the router. Lower route
preference values are preferred when determining the best route.
Format no ip route distance
Mode
ip netdirbcast
This command enables the forwarding of network-directed broadcasts. When enabled,
network directed broadcasts are forwarded. When disabled they are dropped.
Default
Format ip netdirbcast
Mode
no ip netdirbcast
This command disables the forwarding of network-directed broadcasts. When disabled,
network directed broadcasts are dropped.
Format no ip netdirbcast
Mode
ip mtu
This command sets the IP Maximum Transmission Unit (MTU) on a routing interface. The IP
MTU is the size of the largest IP packet that can be transmitted on the interface without
fragmentation. The software currently does not fragment IP packets.
• Packets forwarded in hardware ignore the IP MTU.
• Packets forwarded in software are dropped if they exceed the IP MTU of the outgoing
interface.
Packets originated on the router, such as OSPF packets, may be fragmented by the IP stack.
The IP stack uses its default IP MTU and ignores the value set using the ip mtu command.
1
Global Config
Global Config
disabled
Interface Config
Interface Config
To Next Page
Loading...
Need help?
General