NETGEAR ProSafe GSM7224P - Set Igmp Maxresponse; Set Igmp Groupmembership-Interval

Format no set igmp fast-leave <vlan_id>
Mode
Switching Commands
163
ProSafe Managed Switch
set igmp groupmembership-interval
This command sets the IGMP Group Membership Interval time on a VLAN, one interface or
all interfaces. The Group Membership Interval time is the amount of time in seconds that a
switch waits for a report from a particular group on a particular interface before deleting the
interface from the entry. This value must be greater than the IGMPv3 Maximum Response
time value. The range is 2 to 3600 seconds.
Default
Format set igmp groupmembership-interval <2-3600>
Mode
• Interface Config
• Global Config
Format set igmp groupmembership-interval <vlan_id> <2-3600>
Mode
no set igmp groupmembership-interval
This command sets the IGMPv3 Group Membership Interval time to the default value.
Format no set igmp groupmembership-interval
Mode
• Interface Config
• Global Config
Format no set igmp groupmembership-interval <vlan_id>
Mode
set igmp maxresponse
This command sets the IGMP Maximum Response time for the system, or on a particular
interface or VLAN. The Maximum Response time is the amount of time in seconds that a
switch will wait after sending a query on an interface because it did not receive a report for a
particular group in that interface. This value must be less than the IGMP Query Interval time
value. The range is 1 to 25 seconds.
Default
Format set igmp maxresponse <1-25>
Mode
• Global Config
• Interface Config
VLAN Config
260 seconds
VLAN Config
VLAN Config
10 seconds