NETGEAR ProSafe GSM7224P - Front Panel Stacking Commands; Show Stack-Port; Show Stack-Port Counters

Stacking Commands
29
ProSafe Managed Switch
Front Panel Stacking Commands
This section describes the commands you use to view and configure front panel stacking
information.
stack-port
This command sets front panel stacking per port to either stack or ethernet mode.
Default
Format stack-port <unit/slot/port> [{ethernet | stack}]
Mode
show stack-port
This command displays summary stack-port information for all interfaces.
Format show stack-port
Mode
For Each Interface:
Unit
Interface
Configured Stack
Mode
Running Stack
Mode
Link Status
Link Speed
show stack-port counters
This command displays summary data counter information for all interfaces.
Format show stack-port counters
Mode
stack
Stack Global Config
Privileged EXEC
Term Definition
QOS Mode
Front Panel Stacking QOS Mode for all Interfaces.
Term Definition
The unit number.
The slot and port numbers.
Stack or Ethernet.
Stack or Ethernet.
Status of the link.
Speed (Gbps) of the stack port link.
Privileged EXEC