Switching Commands
39
ProSafe Managed Switch
interface lag
This command gives you access to the LAG (link aggregation, or port channel) virtual
interface, which allows certain port configurations to be applied to the LAG interface. Type a
question mark (?) after entering the interface configuration mode to see the available options.
Note: The IP address cannot be assigned to a LAG virtual interface. The
interface must be put under a VLAN group and an IP address
assigned to the VLAN group.
auto-negotiate
This command enables automatic negotiation on a port.
Default
Format auto-negotiate
Mode
no auto-negotiate
This command disables automatic negotiation on a port.
Note: Automatic sensing is disabled when automatic negotiation is
disabled.
auto-negotiate all
This command enables automatic negotiation on all ports.
Default
Format auto-negotiate all
Mode
Format interface lag <lag id>
Mode
Global Config
enabled
Interface Config
enabled
Global Config
To Next Page
Loading...
Need help?
General