NETGEAR ProSafe GSM7224P - DNS Client Commands; Show Ip Dhcp Conflict; Ip Domain Lookup

Utility Commands
555
ProSafe Managed Switch
Message Sent:
DHCP OFFER
DHCP ACK
DHCP NACK
show ip dhcp conflict
This command displays address conflicts logged by the DHCP Server. If no IP address is
specified, all the conflicting addresses are displayed.
Format show ip dhcp conflict [<ip-address>]
Modes
• Privileged EXEC
• User EXEC
IP address
Detection
Method
Detection time
DNS Client Commands
These commands are used in the Domain Name System (DNS), an Internet directory
service. DNS is how domain names are translated into IP addresses. When enabled, the
DNS client provides a hostname lookup service to other components.
ip domain lookup
Use this command to enable the DNS client.
Default
Format ip domain lookup
Mode
no ip domain lookup
Use this command to disable the DNS client.
Format no ip domain lookup
Mode
Message Definition
The number of DHCPOFFER messages the server sent.
The number of DHCPACK messages the server sent.
The number of DHCPNACK messages the server sent.
Term Definition
The IP address of the host as recorded on the DHCP server.
The manner in which the IP address of the hosts were found on the DHCP Server.
The time when the conflict was found.
enabled
Global Config
Global Config