NETGEAR ProSafe GSM7224P - Clear Pass; Clear Traplog; Clear Vlan; Enable Password

Utility Commands
530
ProSafe Managed Switch
clear pass
This command resets all user passwords to the factory defaults without powering off the
switch. You are prompted to confirm that the password reset should proceed.
Format clear pass
Mode
clear port-channel
This command clears all port-channels (LAGs).
Format clear port-channel
Mode
clear traplog
This command clears the trap log.
Format clear traplog
Mode
clear vlan
This command resets VLAN configuration parameters to the factory defaults.
Format clear vlan
Mode
enable password
This command prompts you to change the Privileged EXEC password. Passwords are a
maximum of 64 alphanumeric characters. The password is case sensitive. The option
[encrypted] allows the administrator to transfer the enable password between devices without
having to know the password. In this case, the <password> parameter must be exactly 128
hexadecimal characters.
Format enable password <password> [encrypted]
Mode
logout
This command closes the current telnet connection or resets the current serial connection.
Privileged EXEC
Privileged EXEC
Privileged EXEC
Privileged EXEC
Privileged EXEC