NETGEAR ProSafe GSM7224P - Link Local Protocol Filtering Commands; Show Ip Address-Conflict; Clear Ip Address-Conflict-Detect; Llpf Blockall

Utility Commands
586
ProSafe Managed Switch
show ip address-conflict
This command displays the status information corresponding to the last detected address
conflict.
Address
Conflict
Detection
Status
Last Conflicting
IP Address
Last Conflicting
MAC Address
Time Since
Conflict
Detected
clear ip address-conflict-detect
This command clears the detected address conflict status information.
Format clear ip address-conflict-detect
Mode
Link Local Protocol Filtering Commands
Link Local Protocol Filtering (LLPF) allows the switch to filter out multiple proprietary protocol
PDUs, such as Port Aggregation Protocol (PAgP), if the problems occur with proprietary
protocols running on standards-based switches. If certain protocol PDUs cause unexpected
results, LLPF can be enabled to prevent those protocol PDUs from being processed by the
switch.
llpf blockall
Use this command to block LLPF protocol(s) on a port. Use blockall to filter all PDUs with a
DMAC of 01:00:00:0C:CC:CX on the interface. Use
blockisdp to filter the ISDP packets on
the interface. Use
blockvtp to filter the VTP packets on the interface. Use blockdtp to filter
the DTP packets on the interface. Use
blockudld to filter the UDLD packets on the interface.
Use
blockpagp to filter the PAGP packets on the interface. Use blocksstp to filter the SSTP
packets on the interface.
Format llpf {blockisdp | blockvtp | blockdtp | blockudld | blockpagp
| blocksstp | blockall }
Mode
Default
Term Definition
Identifies whether the switch has detected an address conflict on any IP address.
The IP Address that was last detected as conflicting on any interface.
The MAC Address of the conflicting host that was last detected on any interface.
The time in days, hours, minutes and seconds since the last address conflict was
detected.
Privileged EXEC
Interface Config
Disable