NETGEAR ProSafe GSM7224P - Ip Helper Enable; Ip Helper-Address

Routing Commands
266
ProSafe Managed Switch
ip helper enable
Use this command to enable relay of UDP packets. This command can be used to
temporarily disable IP helper without deleting all IP helper addresses. This command
replaces the
bootpdhcprelay enable command, but affects not only relay of DHCP
packets, but also relay of any other protocols for which an IP helper address has been
configured.
Default
Format ip helper enable
Mode
no ip helper enable
Use this command to disable relay of all UDP packets.
Format no ip helper enable
Mode
ip helper-address
Use this command to add a unicast helper address to the list of helper addresses on an
interface. This is the address of a DHCP server. This command can be applied multiple times
on the routing interface to form the helper addresses list until the list reaches the maximum
supported helper addresses.
Format ip helper-address <ip-address>
{<1-65535>|dhcp|domain|isakmp|mobile-ip|nameserver|
netbios-dgm|netbios-ns|ntp|pim-auto-rip|rip|tacacs|tftp|time}
Mode
no ip helper-address
Use this command to remove the IP address from the previously configured list. The no
command without an <
ip-address> argument removes the entire list of helper addresses
on that interface.
Format no ip helper-address {<ip-address>}
{<1-65535>|dhcp|domain|isakmp|mobile-ip|nameserver|
netbios-dgm|netbios-ns|ntp|pim-auto-rip|rip|tacacs|tftp|time}
Mode
disabled
Global Config
Global Config
Interface Config
Interface Config