NETGEAR ProSafe GSM7224P - Lldp Med Confignotification; Lldp Med Transmit-Tlv

Switching Commands
195
ProSafe Managed Switch
lldp med confignotification
Use this command to configure all the ports to send the topology change notification.
Default
Format lldp med confignotification
Mode
no ldp med confignotification
Use this command to disable notifications.
Format no lldp med confignotification
Mode
lldp med transmit-tlv
Use this command to specify which optional Type Length Values (TLVs) in the LLDP MED set
will be transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs).
Default
Format lldp med transmit-tlv [capabilities] [ex-pd] [ex-pse] [inventory]
[location] [network-policy]
Mode
capabilities
ex-pd
ex-pse
inventory
location
network-policy
no lldp med transmit-tlv
Use this command to remove a TLV.
Format no lldp med transmit-tlv [capabilities] [network-policy] [ex-pse]
[ex-pd] [location] [inventory]
Mode
enabled
Interface Config
Interface Config
By default, the capabilities and network policy TLVs are included.
Interface Config
Term Definition
Transmit the LLDP capabilities TLV.
Transmit the LLDP extended PD TLV.
Transmit the LLDP extended PSE TLV.
Transmit the LLDP inventory TLV.
Transmit the LLDP location TLV.
Transmit the LLDP network policy TLV.
Interface Config