NETGEAR ProSafe GSM7224P - Shutdown All

Switching Commands
41
ProSafe Managed Switch
Note: You can use the shutdown command on physical and port-channel
(LAG) interfaces, but not on VLAN routing interfaces.
no shutdown
This command enables a port.
Format no shutdown
Mode
shutdown all
This command disables all ports.
Note: You can use the shutdown all command on physical and
port-channel (LAG) interfaces, but not on VLAN routing interfaces.
no shutdown all
This command enables all ports.
Format no shutdown all
Mode
speed
This command sets the speed and duplex setting for the interface.
Format speed {<100 | 10> <half-duplex | full-duplex>}
Mode
Format shutdown
Mode
Interface Config
Interface Config
Format shutdown all
Mode
Global Config
Global Config
Interface Config