NETGEAR ProSafe GSM7224P - Dos-Control Tcpport; Dos-Control Udpport

Switching Commands
208
ProSafe Managed Switch
this type of attack. If packets ingress with SMAC=DMAC, the packets will be dropped if the
mode is enabled.
Default
Format dos-control smacdmac
Mode
no dos-control smacdmac
This command disables Source MAC address = Destination MAC address (SMAC=DMAC)
Denial of Service protection.
Format no dos-control smacdmac
Mode
dos-control tcpport
This command enables TCP L4 source = destination port number (Source TCP Port =
Destination TCP Port) Denial of Service protection. If the mode is enabled, Denial of Service
prevention is active for this type of attack. If packets ingress with Source TCP Port =
Destination TCP Port, the packets will be dropped if the mode is enabled.
Default
Format dos-control tcpport
Mode
no dos-control tcpport
This command disables TCP L4 source = destination port number (Source TCP Port =
Destination TCP Port) Denial of Service protection.
Format no dos-control smacdmac
Mode
dos-control udpport
This command enables UDP L4 source = destination port number (Source UDP Port =
Destination UDP Port) Denial of Service protection. If the mode is enabled, Denial of Service
prevention is active for this type of attack. If packets ingress with Source UDP Port =
Destination UDP Port, the packets will be dropped if the mode is enabled.
Default
Format dos-control udppport
Mode
disabled
Global Config
Global Config
disabled
Global Config
Global Config
disabled
Global Config