NETGEAR ProSafe GSM7224P - Show Sysinfo; Show Running-Config Interface; Show Tech-Support

Utility Commands
514
ProSafe Managed Switch
• If all the flags in a particular group are enabled, then the command displays trapflags
<group name> all.
• If some, but not all, of the flags in that group are enabled, the command displays
trapflags <groupname> <flag-name>.
show running-config interface
This command shows the current configuration on a particular interface. The interface could
be a physical port or a virtual port—like a LAG or VLAN. The output captures how the
configuration differs from the factory default value.
Format
Mode
show sysinfo
This command displays switch information.
Format show sysinfo
Mode
Switch
Description
System Name
System
Location
System Contact
System Object
ID
System Up Time
MIBs Supported
show tech-support
Use the show tech-support command to display system and configuration information
when you contact technical support. The output of the show tech-support command
combines the output of the following commands:
Format show running-config [all | <scriptname> | changed]
Mode
Privileged EXEC
show running-config interface {<unit/slot/port>} | VLAN <id> | LAG <id>}
Interface Config
Privileged EXEC
Term Definition
Text used to identify this switch.
Name used to identify the switch. The factory default is blank. To configure the system
name, see snmp-server on page 628.
Text used to identify the location of the switch. The factory default is blank. To configure
the system location, see snmp-server on page 628.
Text used to identify a contact person for this switch. The factory default is blank. To
configure the system location, see snmp-server on page 628.
The base object ID for the switch’s enterprise MIB.
The time in days, hours and minutes since the last switch reboot.
A list of MIBs supported by this agent.