NETGEAR ProSafe GSM7224P - Set Gvrp Adminmode; Set Gvrp Interfacemode; Show Gvrp Configuration

Switching Commands
88
ProSafe Managed Switch
set gvrp adminmode
This command enables GVRP on the system.
Default
Format set gvrp adminmode
Mode
no set gvrp adminmode
This command disables GVRP.
Format no set gvrp adminmode
Mode
set gvrp interfacemode
This command enables GVRP on a single port (Interface Config mode) or all ports (Global
Config mode).
Default
Format set gvrp interfacemode
Mode
• Interface Config
• Global Config
no set gvrp interfacemode
This command disables GVRP on a single port (Interface Config mode) or all ports (Global
Config mode). If GVRP is disabled, Join Time, Leave Time and Leave All Time have no
effect.
Format no set gvrp interfacemode
Mode
• Interface Config
• Global Config
show gvrp configuration
This command displays Generic Attributes Registration Protocol (GARP) information for one
or all interfaces.
Format show gvrp configuration {<unit/slot/port> | all}
Mode
• Privileged EXEC
• User EXEC
disabled
Privileged EXEC
Privileged EXEC
disabled