NETGEAR ProSafe GSM7224P - Dos-Control Icmp; Dos-Control Smacdmac

Switching Commands
207
ProSafe Managed Switch
Note: Some applications mirror source and destination L4 ports - RIP for
example uses 520 for both. If you enable dos-control l4port,
applications such as RIP may experience packet loss which would
render the application inoperable.
no dos-control l4port
This command disables L4 Port Denial of Service protections.
Format no dos-control l4port
Mode
dos-control icmp
This command enables Maximum ICMP Packet Size Denial of Service protections. If the
mode is enabled, Denial of Service prevention is active for this type of attack. If ICMP Echo
Request (PING) packets ingress having a size greater than the configured value, the packets
will be dropped if the mode is enabled.
Default
Format dos-control icmp [<0-1023>]
Mode
no dos-control icmp
This command disables Maximum ICMP Packet Size Denial of Service protections.
Format no dos-control icmp
Mode
dos-control smacdmac
This command enables Source MAC address = Destination MAC address (SMAC=DMAC)
Denial of Service protection. If the mode is enabled, Denial of Service prevention is active for
Default
disabled
Format dos-control l4port
Mode
Global Config
Global Config
disabled <512>
Global Config
Global Config