NETGEAR ProSafe GSM7224P - Ip Igmp Last-Member-Query-Count; Ip Igmp Last-Member-Query-Interval; Ip Igmp Query-Interval

IP Multicast Commands
341
ProSafe Managed Switch
ip igmp last-member-query-count
This command sets the number of Group-Specific Queries sent before the router assumes
that there are no local members on the interface. The range for <count> is 1 to 20.
Format ip igmp last-member-query-count <count>
Modes
no ip igmp last-member-query-count
This command resets the number of Group-Specific Queries to the default value.
Format no ip igmp last-member-query-count
Modes
ip igmp last-member-query-interval
This command configures the Maximum Response Time inserted in Group-Specific Queries
which are sent in response to Leave Group messages. The range for <seconds> is 0 to 255
tenths of a second.
Default
Format ip igmp last-member-query-interval <seconds>
Modes
no ip igmp last-member-query-interval
This command resets the Maximum Response Time to the default value.
Format no ip igmp last-member-query-interval
Modes
ip igmp query-interval
This command configures the query interval for the specified interface. The query interval
determines how fast IGMP Host-Query packets are transmitted on this interface. The range
for <queryinterval> is 1 to 3600 seconds.
Default
Format ip igmp query-interval <seconds>
Modes
Interface Config
Interface Config
10 tenths of a second (1 second)
Interface Config
Interface Config
125 seconds
Interface Config