231
5
5. Routing Commands
This chapter describes the routing commands available in the 7000 series CLI.
Note: Commands described in this chapter that require a license are:
Router Discovery Protocol Commands
Virtual Router Redundancy Protocol Commands
Open Shortest Path First (OSPF) Commands
OSPF Graceful Restart Commands
Routing Information Protocol (RIP) Commands
This chapter contains the following sections:
• Address Resolution Protocol (ARP) Commands
• IP Routing Commands
• Router Discovery Protocol Commands
• Virtual LAN Routing Commands
• Virtual Router Redundancy Protocol Commands
• DHCP and BOOTP Relay Commands
• IP Helper Commands
• Open Shortest Path First (OSPF) Commands
• OSPF Graceful Restart Commands
• Routing Information Protocol (RIP) Commands
• ICMP Throttling Commands
The commands in this chapter are in three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
• Clear commands clear some or all of the settings to factory defaults.
To Next Page
Loading...
