NETGEAR ProSafe GSM7224P - Mac Access-List Extended Rename; Deny | Permit} (Mac Acl)

Quality of Service (QoS) Commands
471
ProSafe Managed Switch
mac access-list extended rename
This command changes the name of a MAC Access Control List (ACL). The <name>
parameter is the name of an existing MAC ACL. The <newname> parameter is a
case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the MAC
access list.
This command fails if a MAC ACL by the name <newname> already exists.
Format mac access-list extended rename <name> <newname>
Mode
{deny | permit} (MAC ACL)
This command creates a new rule for the current MAC access list. Each rule is appended to
the list of configured rules for the list.
Note: The 'no' form of this command is not supported, since the rules
within a MAC ACL cannot be deleted individually. Rather, the entire
MAC ACL must be deleted and re-specified.
Note: An implicit 'deny all' MAC rule always terminates the access list.
A rule may either deny or permit traffic according to the specified classification fields. At a
minimum, the source and destination MAC value must be specified, each of which may be
substituted using the keyword any to indicate a match on any value in that field. The
remaining command parameters are all optional, but the most frequently used parameters
appear in the same relative order as shown in the command format.
The Ethertype may be specified as either a keyword or a four-digit hexadecimal value from
0x0600-0xFFFF. The currently supported <ethertypekey> values are: appletalk, arp,
ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp. Each of these
translates into its equivalent Ethertype value(s).
The time-range parameter allows imposing time limitation on the MAC ACL rule
as
defined by the parameter <time-range-name>. If a time range with the specified namedoes
not exist and the MAC ACL containing this ACL rule is applied to an interface orbound to a
VLAN, then the ACL rule is applied immediately. If a time range withspecified name exists
and the MAC ACL containing this ACL rule is applied to aninterface or bound to a VLAN, then
Global Config