NETGEAR ProSafe GSM7224P - Deleteport (Global Config); Lacp Admin Key; Lacp Collector Max-Delay

Switching Commands
119
ProSafe Managed Switch
deleteport (Interface Config)
This command deletes the port from the port-channel (LAG). The interface is a logical
unit/slot/port number or a group ID of a configured port-channel.
Format deleteport {<logical unit/slot/port>|lag <lag-group-id>}
Mode
deleteport (Global Config)
This command deletes all configured ports from the port-channel (LAG). The interface is a
logical unit/slot/port number of a configured port-channel. To clear the port channels, see
clear port-channel on page 530
Format deleteport <logical unit/slot/port>
Mode
.
lacp admin key
Use this command to configure the administrative value of the key for the port-channel. The
value range of <key> is 0 to 65535.
Default
Format lacp admin key <key>
Mode
Note: This command is only applicable to port-channel interfaces.
no lacp admin key
Use this command to configure the default administrative value of the key for the
port-channel.
Format no lacp admin key
Mode
lacp collector max-delay
Use this command to configure the port-channel collector max delay. The valid range of
<delay> is 0-65535.
Interface Config
Global Config
0x8000
Interface Config
Interface Config
Default
0x8000