NETGEAR ProSafe GSM7224P - Show Ip Pim Ssm

PIM Mode
Data Threshold
Rate)
Register
Rate-limit
Interface
Interface-Mode
Operational-Sta
tus
IP Multicast Commands
337
ProSafe Managed Switch
Example 1:
(Switch) #show ip pim
PIM Mode Dense
Data Threshold Rate (kbps) 0
Register Rate-limit (kbps) 0
Interface Interface-Mode Operational-Status
--------- -------------- ------------------
1/0/1 Enabled Operational
1/0/3 Disabled Non-Operational
Example 2:
(Switch) #show ip pim
PIM Mode Sparse
Data Threshold Rate (kbps) 500
Register Rate-limit (kbps) 100
Interface Interface-Mode Operational-Status
--------- -------------- ------------------
1/0/1 Enabled Operational
1/0/3 Disabled Non-Operational
show ip pim ssm
This command shows the configured source specific IP multicast addresses.
Format show ip pim ssm
Mode
Group Address
Prefix Length
(Switch) #show ip pim ssm
Group Address/Prefix Length
----------------------------
232.0.0.0/8
Term Definition
Configured mode of PIM protocol (enabled or disabled).
Rate (in kbps) of SPT Threshold.
Rate (in kbps) of Register Threshold.
Interface number.
Enable status of the interface.
Operational Status of the Interface.
Privileged EXEC
Term Definition
The address of the SSM Group.
Prefix Length of the SSM Group.