NETGEAR ProSafe GSM7224P - Show Ip Route Preferences

Connected
Routes
Static Routes
RIP Routes
OSPF Routes
Reject Routes
Total Routes
Routing Commands
249
ProSafe Managed Switch
The following shows example CLI display output for the command.
(Switch) #show ip route summary
Connected Routes..............................1
Static Routes.................................7
RIP Routes....................................0
BGP Routes....................................0
OSPF Routes...................................0
Intra Area Routes...........................0
Inter Area Routes...........................0
External Type-1 Routes......................0
External Type-2 Routes......................0
Reject Routes.................................2
Total routes..................................8
show ip route preferences
This command displays detailed information about the route preferences. Route preferences
are used in determining the best route. Lower router preference values are preferred over
higher router preference values. A route with a preference of 255 cannot be used to forward
traffic.
Format show ip route preferences
Modes
• Privileged EXEC
• User EXEC
Local
Static
OSPF Intra
OSPF Inter
OSPF External
RIP
Term Definition
The total number of connected routes in the routing table.
Total number of static routes in the routing table.
Total number of routes installed by RIP protocol.
Total number of routes installed by OSPF protocol.
Total number of reject routes installed by all protocols.
Total number of routes in the routing table.
Term Definition
The local route preference value.
The static route preference value.
The OSPF Intra route preference value.
The OSPF Inter route preference value.
The OSPF External route preference value.
The RIP route preference value.