NETGEAR ProSafe GSM7224P - Show Ip Ospf Interface Brief

Routing Commands
298
ProSafe Managed Switch
The information below will only be displayed if OSPF is enabled.
OSPF Interface
Type
State
Designated
Router
Backup
Designated
Router
Number of Link
Events
Local Link LSAs
Local Link LSA
Checksum
show ip ospf interface brief
This command displays brief information for the IFO object or virtual interface tables.
Format show ip ospf interface brief
Mode
• Privileged EXEC
• User EXEC
Interface
OSPF Admin
Mode
OSPF Area ID
Router Priority
Hello Interval
Dead Interval
Retransmit
Interval
Retransmit
Delay Interval
LSA Ack
Interval
Term Definition
Broadcast LANs, such as Ethernet and IEEE 802.5, take the value broadcast. The
OSPF Interface Type will be 'broadcast'.
The OSPF Interface States are: down, loopback, waiting, point-to-point, designated
router, and backup designated router.
The router ID representing the designated router.
The router ID representing the backup designated router.
The number of link events.
The number of Link Local Opaque LSAs in the link-state database.
The sum of LS Checksums of Link Local Opaque LSAs in the link-state database.
Term Definition
Valid slot and port number separated by forward slashes.
States whether OSPF is enabled or disabled on a router interface.
The OSPF Area Id for the specified interface.
A number representing the OSPF Priority for the specified interface.
A number representing the OSPF Hello Interval for the specified interface.
A number representing the OSPF Dead Interval for the specified interface.
A number representing the OSPF Retransmit Interval for the specified interface.
A number representing the OSPF Transit Delay for the specified interface.
A number representing the OSPF LSA Acknowledgment Interval for the specified
interface.