NETGEAR ProSafe GSM7224P - DHCP Server Commands

Utility Commands
543
ProSafe Managed Switch
show clock
Use the show clock command in Privileged EXEC or User EXEC mode to display the time
and date from the system clock. Use the show clock detail command to show the time zone
and summertime configuration.
DHCP Server Commands
This section describes the commands you to configure the DHCP server settings for the
switch. DHCP uses UDP as its transport protocol and supports a number of features that
facilitate in administration address allocations.
ip dhcp pool
This command configures a DHCP address pool name on a DHCP server and enters DHCP
pool configuration mode.
Default
Format ip dhcp pool <name>
Mode
Last Update
Status
Last server attempt status for the server.
Total Unicast
Requests
Number of requests to the server.
Failed Unicast
Requests
Number of failed requests from server.
Format show clock [detail]
Mode User EXEC
Privileged EXEC
Term Definition
Time
The time provided by the time source.
Time Source
The time source type.
If option detail is specified, these terms are displayed
Time Zone
The time zone configured.
Summer Time
Indicate if the summer time is enabled.
none
Global Config
Term Definition