NETGEAR ProSafe GSM7224P - Debug Ping Packet; Debug Ipv6 Ospfv3 Packet

Utility Commands
574
ProSafe Managed Switch
LS_ACK packet field definitions.
Length
no debug ospf packet
This command disables tracing of OSPF packets.
Format no debug ospf packet
Mode
debug ipv6 ospfv3 packet
Use this command to enable OSPFv3 packet debug trace.
Default
Format debug ipv6 ospfv3 packet
Mode
no debug ipv6 ospfv3 packet
Use this command to disable tracing of OSPFv3 packets.
Format no debug ipv6 ospfv3 packet
Mode
debug ping packet
This command enables tracing of ICMP echo requests and responses. The command traces
pings on the network port/ serviceport for switching packages. For routing packages, pings
are traced on the routing ports as well.
Default
Format debug ping packet
Mode
A sample output of the trace message is shown below.
<15> JAN 01 00:21:22 192.168.17.29-1 SIM[181040176]: sim_debug.c(128) 20 % Pkt TX - Intf:
1/0/1(1),
SRC_IP:10.50.50.2, DEST_IP:10.50.50.1, Type:ECHO_REQUEST
<15> JAN 01 00:21:22 192.168.17.29-1 SIM[182813968]: sim_debug.c(82) 21 % Pkt RX - Intf:
1/0/1(1), S
Field Definition
Length of packet
Privileged EXEC
disabled
Privileged EXEC
Privileged EXEC
disabled
Privileged EXEC