NETGEAR ProSafe GSM7224P - Ipv6 Pim Rp-Candidate; Ipv6 Pim Spt-Threshold

IPv6 Multicast Commands
426
ProSafe Managed Switch
there is a conflict, the RP configured with this command prevails over the RP learned by
BSR.
Default
Format ipv6 pim rp-address <rp-address> <group-address> <group-mask>
[override]
Mode
no ipv6 pim rp-address
Use this command to statically remove the RP address for one or more multicast groups.
Format no ipv6 pim rp-address <rp-address> <group-address> <group-mask>
Mode
ipv6 pim rp-candidate
Use this command to configure the router to advertise itself as a PIM candidate rendezvous
point (RP) to the bootstrap router (BSR).
Default
Format ipv6 pim rp-candidate interface <unit/slot/port> <group-address>
<group-mask>
Mode
no ipv6 pim rp-candidate
Use this command to disable the router to advertise itself as a PIM candidate rendezvous
point (RP) to the bootstrap router (BSR).
Format no ipv6 pim rp-candidate interface <unit/slot/port> <group-address>
<group-mask>
Mode
ipv6 pim spt-threshold
Use this command to configure the Data Threshold rate for the last-hop router to switch to the
shortest path. The rate is specified in Kilobits per second. The possible values are 0 to 2000.
Default
Format ipv6 pim spt-threshold <1-2000>
Mode
0
Global Config
Global Config
None
Global Config
Global Config
0
Global Config