NETGEAR ProSafe GSM7224P - Sntp Client Mode; Sntp Client Port; Sntp Unicast Client Poll-Interval

Utility Commands
537
ProSafe Managed Switch
sntp client mode
This command enables Simple Network Time Protocol (SNTP) client mode and may set the
mode to either broadcast or unicast.
Default
Format sntp client mode [broadcast | unicast]
Mode
no sntp client mode
This command disables Simple Network Time Protocol (SNTP) client mode.
Format no sntp client mode
Mode
sntp client port
This command sets the SNTP client port id to a value from 1-65535.
Default
Format sntp client port <portid>
Mode
no sntp client port
This command resets the SNTP client port back to its default value.
Format no sntp client port
Mode
sntp unicast client poll-interval
This command sets the poll interval for SNTP unicast clients in seconds as a power of two
where <poll-interval> can be a value from 6 to 10.
Default
Format sntp unicast client poll-interval <poll-interval>
Mode
disabled
Global Config
Global Config
123
Global Config
Global Config
6
Global Config