NETGEAR ProSafe GSM7224P - Show Lldp Remote-Device

Switching Commands
191
ProSafe Managed Switch
show lldp remote-device
Use this command to display summary information about remote devices that transmit
current LLDP data to the system. You can show information about LLDP remote data
received on all ports or on a specific port.
Format show lldp remote-device {<unit/slot/port> | all}
Mode
Local Interface
RemID
Chassis ID
Port ID
System Name
Example: The following shows example CLI display output for the command.
(switch) #show lldp remote-device all
LLDP Remote Device Summary
Local
Interface RemID Chassis ID Port ID System Name
------- ------- -------------------- ------------------ ------------------
0/1
0/2
0/3
0/4
0/5
0/6
0/7 2 00:FC:E3:90:01:0F 00:FC:E3:90:01:11
0/7 3 00:FC:E3:90:01:0F 00:FC:E3:90:01:12
0/7 4 00:FC:E3:90:01:0F 00:FC:E3:90:01:13
Ageouts
Total number of times a complete remote data entry was deleted for the port because the
Time to Live interval expired.
TLV Discards
The number of TLVs discarded.
TLV Unknowns
Total number of LLDP TLVs received on the port where the type value is in the reserved
range, and not recognized.
TLV MED
Total number of LLDP MED TLVs received on the local ports.
TVL802.1
Total number of 802.1 LLDP TLVs received on the local ports.
TVL802.3
Total number of 802.3 LLDP TLVs received on the local ports.
Privileged EXEC
Term Definition
The interface that received the LLDPDU from the remote device.
An internal identifier to the switch to mark each remote device to the system.
The ID that is sent by a remote device as part of the LLDP message, it is usually a MAC
address of the device.
The port number that transmitted the LLDPDU.
The system name of the remote device.
Term Definition