NETGEAR ProSafe GSM7224P - DVMRP Commands; Ip Dvmrp(Global Config); Ip Dvmrp Metric

IP Multicast Commands
324
ProSafe Managed Switch
If you use the summary parameter, the command displays the following column headings in
the output table:
Source IP
Group IP
Protocol
Incoming
Interface
Outgoing
Interface List
DVMRP Commands
This section provides a detailed explanation of the Distance Vector Multicast Routing
Protocol (DVMRP) commands.
ip dvmrp(Global Config)
This command sets administrative mode of DVMRP in the router to active.
Default
Format ip dvmrp
Mode
no ip dvmrp(Global Config)
This command sets administrative mode of DVMRP in the router to inactive.
Format no ip dvmrp
Mode
ip dvmrp metric
This command configures the metric for an interface. This value is used in the DVMRP
messages as the cost to reach this network. This field has a range of 1 to 31.
Default
Format ip dvmrp metric <metric>
Mode
Term Definition
The IP address of the multicast data source.
The IP address of the destination of the multicast packet.
The multicast routing protocol by which this entry was created.
The interface on which the packet for this source arrives.
The list of outgoing interfaces on which this packet is forwarded.
disabled
Global Config
Global Config
1
Interface Config