Switching Commands
129
ProSafe Managed Switch
port-channel adminmode
This command enables a port-channel (LAG). This command sets every configured
port-channel with the same administrative mode setting.
Format port-channel adminmode all
Mode
no port-channel adminmode
This command disables a port-channel (LAG). This command clears every configured
port-channel with the same administrative mode setting.
Format no port-channel adminmode [all]
Mode
port-channel linktrap
This command enables link trap notifications for the port-channel (LAG). The interface is a
logical unit/slot/port for a configured port-channel. The option all
enables link trap
notifications for all the
configured port-channels.
Default
Format port-channel linktrap {<logical unit/slot/port> | all}
Mode
no port-channel linktrap
This command disables link trap notifications for the port-channel (LAG). The interface is a
logical slot and port for a configured port-channel. The option all disables link trap
notifications for all the configured port-channels.
Format no port-channel linktrap {<logical unit/slot/port> | all}
Mode
port-channel load-balance
This command selects the load-balancing option used on a port-channel (LAG). Traffic is
balanced on a port-channel (LAG) by selecting one of the links in the channel over which to
transmit specific packets. The link is selected by creating a binary pattern from selected fields
in a packet, and associating that pattern with a particular link.
Load-balancing is not supported on every device. The range of options for load-balancing
may vary per device. The XSM7224S also supports enhanced hashing mode, which has the
following advantages:
Global Config
Global Config
enabled
Global Config
Global Config
To Next Page
Loading...
