NETGEAR ProSafe GSM7224P - Show Ip Dhcp Global Configuration; Show Ip Dhcp Pool Configuration

IP address
Hardware
Address
Lease
expiration
Type
Utility Commands
553
ProSafe Managed Switch
show ip dhcp global configuration
This command displays address bindings for the specific IP address on the DHCP server. If
no IP address is specified, the bindings corresponding to all the addresses are displayed.
Format show ip dhcp global configuration
Modes
• Privileged EXEC
• User EXEC
Service DHCP
Number of Ping
Packets
Conflict
Logging
BootP
Automatic
show ip dhcp pool configuration
This command displays pool configuration. If all is specified, configuration for all the pools
is displayed.
Format show ip dhcp pool configuration {<name> | all}
Modes
• Privileged EXEC
• User EXEC
Pool Name
Pool Type
Lease Time
DNS Servers
Default Routers
Term Definition
The IP address of the client.
The MAC Address or the client identifier.
The lease expiration time of the IP address assigned to the client.
The manner in which IP address was assigned to the client.
Term Definition
The field to display the status of dhcp protocol.
The maximum number of Ping Packets that will be sent to verify that an ip address id not
already assigned.
Shows whether conflict logging is enabled or disabled.
Shows whether BootP for dynamic pools is enabled or disabled.
Field Definition
The name of the configured pool.
The pool type.
The lease expiration time of the IP address assigned to the client.
The list of DNS servers available to the DHCP client .
The list of the default routers available to the DHCP client