NETGEAR ProSafe GSM7224P - Show Ipv6 Route Preferences; Show Ipv6 Route Summary

IPv6 Commands
370
ProSafe Managed Switch
Codes: C - connected, S - static
O - OSPF Intra, OI - OSPF Inter, OE1 - OSPF Ext 1, OE2 - OSPF Ext 2
ON1 - OSPF NSSA Ext Type 1, ON2 - OSPF NSSA Ext Type 2
S 2001::/64 [10/0] directly connected, Null0
C 2003::/64 [0/0]
via ::, 0/11
S 2005::/64 [1/0]
via 2003::2, 0/11
C 5001::/64 [0/0]
via ::, 0/5
OE1 6001::/64 [110/1]
via fe80::200:42ff:fe7d:2f19, 00h:00m:23s, 0/5
OI 7000::/64 [110/6]
via fe80::200:4fff:fe35:c8bb, 00h:01m:47s, 0/11
show ipv6 route preferences
Use this command to show the preference value associated with the type of route. Lower
numbers have a greater preference. A route with a preference of 255 cannot be used to
forward traffic.
Format show ipv6 route preferences
Mode
Local
Static
OSPF Intra
OSPF Inter
OSPF External
show ipv6 route summary
This command displays the summary of the routing table. Use all to display the count
summary for all routes, including best and non-best routes. Use the command without
parameters to display the count summary for only the best routes.
Format show ipv6 route summary [all]
Modes
• Privileged EXEC
• User EXEC
Privileged EXEC
Term Definition
Preference of directly-connected routes.
Preference of static routes.
Preference of routes within the OSPF area.
Preference of routes to other OSPF routes that are outside of the area.
Preference of OSPF external routes.