NETGEAR ProSafe GSM7224P - Page 9

Using the Command-Line Interface
9
ProSafe Managed Switch
are available from your VAR or NETGEAR authorized e-commerce portal. License activation
is described in the Software Setup Manual.
Command Group or Command XSM7224S GSM7212F/GSM7212P/
GSM7224P/GSM5212P
Front Panel Stacking Commands Supported Not supported
Non-Stop Forwarding Commands Supported Not supported
Stack Firmware Synchronization Commands Supported Not supported
Router Discovery Protocol Commands Require license Not supported
Virtual Router Redundancy Protocol Commands Require license Not supported
Open Shortest Path First (OSPF) Commands Require license Not supported
OSPF Graceful Restart Commands Require license Not supported
Routing Information Protocol (RIP) Commands Require license Not supported
Tunnel Interface Commands Require license Not supported
IPv6 Routing Commands Require license Not supported
OSPFv3 Commands Require license Not supported
OSPFv3 Graceful Restart Commands Require license Not supported
DHCPv6 Commands Require license Not supported
Multicast Commands Require license Not supported
DVMRP Commands Require license Not supported
PIM Commands Require license Not supported
Internet Group Message Protocol (IGMP)
Commands
Require license Not supported
IGMP Proxy Commands Require license Not supported
IPv6 Multicast Forwarder Commands Require license Not supported
IPv6 PIM Commands Require license Not supported
IPv6 MLD Commands Require license Not supported
IPv6 MLD-Proxy Commands Require license Not supported
PoE Commands Not supported Supported
MVR Commands Not supported Supported
Link Local Protocol Filtering Commands Supported Not supported
Priority-Based Flow Control Commands Supported Not supported
Captive Portal Commands Supported Not supported