NETGEAR ProSafe GSM7224P - Page 459

Quality of Service (QoS) Commands
459
ProSafe Managed Switch
redirect
This command specifies that all incoming packets for the associated traffic stream are
redirected to a specific egress interface (physical port or port-channel).
Format redirect <unit/slot/port>
Mode
Incompatibilities
conform-color
Use this command to enable color-aware traffic policing and define the conform-color class
map. Used in conjunction with the police command where the fields for the conform level are
specified. The <class-map-name> parameter is the name of an existing DiffServ class
map.
Note: This command may only be used after specifying a police command
for the policy-class instance.
class
This command creates an instance of a class definition within the specified policy for the
purpose of defining treatment of the traffic class through subsequent policy attribute
statements. The <classname> is the name of an existing DiffServ class.
Note: This command causes the specified policy to create a reference to
the class definition.
Note: The CLI mode is changed to Policy-Class-Map Config when this
command is successfully executed.
Policy-Class-Map Config
Drop, Mirror
Format conform-color <class-map-name>
Mode
Policy-Class-Map Config
Format class <classname>
Mode
Policy-Map Config