NETGEAR ProSafe GSM7224P - Page 479

Quality of Service (QoS) Commands
479
ProSafe Managed Switch
sequence number that is one greater than the highest sequence number currently in use for
this interface and direction is used.
Note: You should be aware that the <out> option may or may not be
available, depending on the platform.
no ip access-group
This command removes a specified IP ACL from an interface.
Default
Format no ip access-group <accesslistnumber> [vlan <vlan-id>] in
Mode
• Interface Config
• Global Config
acl-trapflags
This command enables the ACL trap mode.
Default
Format acl-trapflags
Mode
no acl-trapflags
This command disables the ACL trap mode.
Format no acl-trapflags
Mode
Default
none
Format ip access-group {<accesslistnumber>|<name>} [vlan <vlan-id>] <in |
out>[sequence <1-4294967295>]
Modes
• Interface Config
• Global Config
none
disabled
Global Config
Global Config