NETGEAR ProSafe GSM7224P - Page 534

Utility Commands
534
ProSafe Managed Switch
copy
The copy command uploads and downloads files to and from the switch. You can also use
the copy command to manage the dual images (image1 and image2) on the file system.
Upload and download files from a server by using TFTP or Xmodem. SFTP and SCP are
available as additional transfer methods if the software package supports secure
management.
Format copy <source> <destination>
Mode
Replace the <source> and <destination> parameters with the options in table below.
For the <url> source or destination, use one of the following values:
{xmodem | tftp://<ipaddr|hostname>|<ip6address|hostname>/<filepath>/<filename> [noval]
| sftp|scp://<username>@<ipaddr>|<ipv6address>|<filepath>|<filename>}
For TFTP, SFTP and SCP, the <ipaddr|hostname> parameter is the IP address or host
name of the server, <filepath> is the path to the file, and <filename> is the name of the
file you want to upload or download. For SFTP and SCP, the <username> parameter is the
username for logging into the remote server via SSH.
Note: <ip6address> is also a valid parameter for routing packages that
support IPv6.
For switches that support a USB device, the copy command can be used to transfer files from
and to the USB device. The syntax for the USB file is:
usb://<filename>. The USB device
can be either a source or destination in the copy command. It cannot be used as both source
and destination in a given copy command.
Note: Remember to upload the existing Switch CLI.cfg file off the switch
prior to loading a new release image in order to make a backup.
Parameters for the copy command are listed in the following table:
Privileged EXEC
Source Destination Description
nvram:backup-config nvram:startup-config Copies the backup configuration to the startup
configuration.
nvram:clibanner <url> Copies the CLI banner to a server.
nvram:errorlog <url> Copies the error log file to a server.
nvram:Switch CLI.cfg <url> Uploads the binary config file to a server.