NETGEAR ProSafe GSM7224P - Page 697

Captive Portal Commands
697
ProSafe Managed Switch
no max-bandwidth-down
Use this command to reset the maximum rate to the default.
Format no max-bandwidth-down
Mode
max-bandwidth-up
Use this command to configure the maximum rate at which a client can send data into the
network. The rate is in bits per seconds. 0 indicates limit not enforced.
Default 0
Format max-bandwidth-up <0-536870911>
Mode
no max-bandwidth-up
Use this command to reset the maximum rate to the default.
Format no max-bandwidth-up
Mode
max-input-octets
Use this command to configure the maximum number of octets the user is allowed to
transmit. After this limit has been reached the user will be disconnected. The number of
octets is in bytes. 0 indicates limit not enforced.
Default 0
Format max-input-octets <0-4294967295>
Mode
no max-input-octets
Use this command to reset the limit to the default.
Format no max-input-octets
Mode
Captive Portal Instance mode
Captive Portal Instance mode
Captive Portal Instance mode
Captive Portal Instance mode
Captive Portal Instance mode