NETGEAR ProSafe GSM7224P - Page 699

Captive Portal Commands
699
ProSafe Managed Switch
no session-timeout
Use this command to reset the session timeout to the default.
Format session-timeout <0-86400>
Mode
idle-timeout
Use this command to configure the idle timeout for a captive portal configuration. 0 indicates
timeout not enforced. After an idle session has been reached this, the user will be
disconnected.
Default 0
Format idle-timeout <0-900>
Mode
no idle-timeout
Use this command to reset the idle timeout to the default.
Format no idle-timeout
Mode
locale
This command is not intended to be a user command. The administrator must use the WEB
UI to create and customize captive portal web content. This command is primarily used by
the show running-config command and process as it provides the ability to save and restore
configurations using a text based format.
Default 1
Format locale <1-5>
Mode
no locale
This command is intended to delete a locale. The default locale cannot be deleted.
Format no locale <1-5>
Mode
Captive Portal Instance mode
Captive Portal Instance mode
Captive Portal Instance mode
Captive Portal Instance mode
Captive Portal Instance mode