NETGEAR ProSafe GSM7224P - Page 714

Captive Portal Commands
714
ProSafe Managed Switch
If the user ID is specified, the following terms are displayed.
Password
Configured
Max Bandwidth
Up (bytes/sec)
Max Bandwidth
Down (bytes/sec)
Max Input Octets
(bytes)
Max Output
Octets (bytes)
Max Total Octets
(bytes)
Example
(switch)#show captive-portal user
Session Idle
User ID User Name Timeout Timeout Group ID Group Name
------- -------------- -------- -------- -------- -----------
1 user123 10 13 1
Default
2 user234 0 0 1 Default
(switch)#show captive-portal user 1
User ID........................................ 1
User Name...................................... user123
Password Configured............................ Yes
Session Timeout................................ 0
Idle Timeout................................... 0
Max Bandwidth Up (bytes/sec)................... 0
Max Bandwidth Down (bytes/sec)................. 0
Max Input Octets (bytes)....................... 0
Max Output Octets (bytes)...................... 0
Max Total Octets (bytes)....................... 0
Group ID Group Name
-------- --------------------------------
1 Default
2 group2
Term Definition
If the password is configured.
Maximum client transmit rate (b/s). Limits the bandwidth at which the client can send
data into the network. If the value is 0 then use the value configured for the captive
portal.
Maximum client receive rate (b/s). Limits the bandwidth at which the client can receive
data from the network. If the value is 0 or then use the value configured for the captive
portal.
Maximum number of octets the user is allowed to transmit.After this limit has been
reached the user will be disconnected. If the value is 0 then use the value configured
for the captive portal.
Maximum number of octets the user is allowed to receive. After this limit has been
reached the user will be disconnected. If the attribute is 0 then use the value
configured for the captive portal.
Maximum number of octets the user is allowed to transfer (sum of octets transmitted
and received). After this limit has been reached the user will be disconnected. If the
value is 0 then use the value configured for the captive portal.