Operating Manual 6175.4760.02 – 01 3.31
M3SR Series 4100 Control and Monitoring of Radio and Control Unit
Figure 3.15 Selecting Remote Radio
1 Remote
2 Local
By pressing the 'Connect to Radio' softkey a list of logical addresses of radios which
are configured in the control unit is opened. In case of a built-in control unit the 'LO-
CAL' address might also be listed (see 1 and 2). Select 'LOCAL' to connect to the local
radio. If the list is empty or the desired radio is not listed, the address list must first
be modified (see sect. 3.5.3 Control Unit MTC 3/4 (4003)). Each control unit has an ad-
dress list (logical addresses with associated IP addresses, one of the listed addresses
can be specified as local). A connection can only be established to radios that are list-
ed. For more information refer to sect. 3.5.3 Control Unit MTC 3/4 (4003) and
sect. 3.4 Radio Maintenance.
Now the control unit tries to establish a connection to the selected radio, and the following
screen appears:
1
2
ICN-4D-C-231000-R-D0894-00101-A-01-1
To Next Page
Loading...