Operating Manual 6175.4760.02 – 01 2.27
M3SR Series 4100 Automatic Update of Modules
2.6.1 Automatic Update of Modules
The radios test the firmware versions of connected internal and external hardware modules
after switching on. If any old or wrong versions are detected, an automatic update is offered
to ensure optimal performance of the radio system. If the operator does not accept the of-
fered update within 30 seconds, the radio continues its boot process as usual.
If not performing the update process, the radio will indicate the wrong module firmware ver-
sions after startup with warnings. In addition, the error list will contain the message "UPDATE
NEEDED".
As long as the update is offered or running, it is not possible to operate the radio and
only a reduced set of remote commands is available. Please refer to the remote inter-
face documentation for details.
Automatic Update is supported for the following modules:
• Frontend
•Synthesizer
• Motherboard
• R&S GS4102
• R&S FK4120 / R&S FK4140
• R&S VK4115
• R&S VK4150 / R&S VK4150
•PMU
• FK4115x
• FK4190x
To Next Page
Loading...