Operating Manual 6175.4760.02 – 01 4.197
M3SR Series 4100 Inserting a User Hopset Subband
Inserting a User Hopset Subband
By means of softkey 'Insert' the operator can insert a user hopset subband.
Softkey Type Description
Example for adding a new hopset band with
the range of 2000 kHz up to 5000 kHz
Start from band menu of the desired user
hopset.
1. Press softkey 'Insert' to open hopset fre-
quency editor.
2. Edit desired lower hopset band frequency.
3. Press 'ENT' to confirm.
4. Edit desired higher hopset band frequen-
cy.
5. Press 'ENT' to confirm.
6. To complete the insertion press the 'Save'
softkey.
The insertion is now complete.
The frequency spacing is 5 kHz (via MMI).
If the operator tries to insert a hopset sub-
band with a total frequency spacing differ-
ent from a multiple of 5 kHz, the radio will
adapt the higher frequency automatically
after saving the changes.
Press 'Insert' to change to frequency editor.
The frequency editor for Low Frequency will
open.
Enter lower frequency of new subband.
To Next Page
Loading...